Close
FC-106 is a fluorinated polymeric surface control additive engineered to deliver exceptional wetting, levelling, and gloss enhancement in epoxy coating systems applied on granite, marble, and natural stone surfaces.
It works by significantly lowering surface tension at the coating–substrate interface, enabling epoxy systems to spread uniformly, anchor effectively, and form defect-free films on dense, low-energy stone substrates.
In stone epoxy applications—where polished granite, resin-treated slabs, or compact natural stones often cause beading, poor flow, fisheyes, or uneven gloss—FC-106 provides a reliable solution to achieve smooth, high-gloss, professional finishes with improved coating consistency.
Zeolite Silver Antimicrobial Powder/ Ag-Zeolite Powder
1318-02-1
215-283-8
3824.99.00
not classified as dangerous goods
2.1–2.3 g/cm³
4–5
0.1%
Clear epoxy top coats on granite and natural stone
Pigmented epoxy coatings for stone flooring and slabs
Decorative and protective epoxy systems for countertops and panels
High-gloss stone coatings
Resin-rich epoxy finishes on dense substrates
Premium architectural stone applications
| Parameter | Unit | Specification |
|---|---|---|
| Product Name | — | FC 106 |
| Product Type | — | Nonionic fluorosurfactant |
| Chemistry | — | C8 |
| Active Content | % (w/w) | 100 |
| Physical Form @ 25°C | — | Clear to pale yellow viscous liquid |
| Ionic Character | — | Nonionic |
| Density @ 25°C | g/cm³ | 1.05 – 1.25 |
| Viscosity @ 25°C | mPa·s (cP) | 1000 – 2000 |
| Water Solubility | — | Soluble / dispersible |
| Solubility in Common Solvents | — | Soluble in alcohols, glycol ethers; compatible with many ketones/esters (trial recommended) |
| Cloud Point (1% aq.) | °C | 20 – 40 |
| pH (1% aq.) | — | 5.0 – 7.5 |
| Surface Tension (0.1% in water) | mN/m | ≤ 18 |
| Interfacial Tension (0.1% vs mineral oil) | mN/m | ≤ 2 (typical) |
| Critical Micelle Concentration (CMC) | % | 0.01 – 0.05 (typical) |
| Flash Point | °C | > 100 (typical) |
Enables epoxy coatings to spread uniformly on polished granite and low-porosity stones.
Improves levelling and film flow, resulting in a smoother, higher-gloss appearance.
Minimizes fisheyes, craters, pinholes, and poor edge wetting caused by surface tension imbalance.
Supports uniform coating build and reduces rework caused by coating defects.
Delivers strong performance at ppm-level addition without altering bulk coating properties.
Helps formulators achieve consistent, showroom-grade stone finishes.
Exact dosage depends on epoxy formulation, solvent content, and substrate condition. Always validate through lab and field trials.
Dosage: 0.01 – 0.10% on total formulation (100–1000 ppm)
Dosage: 0.02 – 0.08% on total formulation
Note: Over-dosage may reduce intercoat adhesion or cause surface slip; optimal dosing is critical.
Safety goggles
Protective gloves
Adequate ventilation during use
Refer to the Safety Data Sheet (SDS) for complete safety and regulatory information.